Refrigerator · Samsung
Samsung Refrigerator Not Cooling: Cooling Off Mode, Codes and Fixes
Samsung fridge or freezer not cooling? Rule out Cooling Off (Demo) Mode, check for an error code, then work through Samsung's airflow, seal and reset steps.
Last verified November 16, 2026
Start here
Before you begin, make sure the refrigerator is plugged in and set up normally —cooling off mode (demo or shop mode) is on: the display shows of of, o ff, off off or scrolling temperature bars, and the fridge won't cool.
Start troubleshootingSafety notice
If an error code is showing, don't unplug the fridge or press panel buttons to make the code go away unless that code's instructions tell you to. Samsung says this makes it harder for a technician to diagnose.
View detailed safety tipsMost Likely Causes
Based on common issues for this problem.
- 1Cooling Off Mode (Demo or Shop mode) is on: the display shows OF OF, O FF, OFF OFF or scrolling temperature bars, and the fridge won't cool
- 2A fan error such as 21E or 22E, usually a fan frozen up after a door was left open or a gasket gap
- 3The temperature was changed recently. Samsung says it can take up to 28 hours to reach the new setting
- 4Blocked airflow: less than 2 inches of clearance around the fridge, or food or frost in front of the interior vents
- 5Door seals that are dirty, damaged, or misaligned because the fridge isn't level
Also described as: “Samsung fridge not cold”, “Samsung refrigerator stopped cooling”, “Samsung freezer not freezing”, “Samsung fridge not cooling but freezer works”
Where to Start
First question: is at least one compartment still cooling? If neither is, check power and Cooling Off Mode first — Cooling Off Mode alone explains a Samsung fridge with a working display and no cooling. If one compartment is cold, or both are just not cold enough, skip to the error code, settings, airflow and door-seal checks.
Is at least one compartment still cooling?
No, neither is cold
Check that the fridge has power, then look for OF OF, O FF, OFF OFF or scrolling bars (Cooling Off Mode). Then check the seals and power cycle it.
Yes, or just not cold enough
Check for an error code, give a new temperature setting up to 28 hours, then check clearance, vents, loading and the door seals.
Steps, codes and timings sourced from Samsung's US support documentation (cooling issues, Cooling Off Mode, refrigerator error codes and frost pages). Reviewed November 16, 2026.
Safety Notes
- If an error code is showing, don't unplug the fridge or press panel buttons to make the code go away unless that code's instructions tell you to. Samsung says this makes it harder for a technician to diagnose.
- Never use a hair dryer to speed up defrosting. Samsung says it will damage the refrigerator.
- Turn off power before disconnecting the wire harness above the door (the PC ER / PC CH fix).
If your Samsung refrigerator has power but isn’t cooling, check the display before anything else. A surprising number of “broken” Samsung fridges are simply in Cooling Off Mode, which shuts off cooling, ice and water but leaves the display on. If it isn’t that, Samsung’s fridges usually show a code for fan and power faults, so you rarely have to guess.
If one compartment is cold and the other isn’t, or neither is quite cold enough, the general checks in the main refrigerator not cooling guide also apply. This page covers what’s specific to Samsung. More Samsung guides are on the Samsung brand page.
Diagnostic Steps
Your progress
0 of 6 steps checked
Rule out Cooling Off Mode (Demo Mode)
- What to look for
- OF OF, O FF, OFF OFF, or temperature bars scrolling back and forth on the display. On Family Hub models, Fridge Manager shows OFF for every compartment.
- What it indicates
- Cooling Off Mode, also called Demo or Shop mode, turns off cooling, ice making and the water dispenser, but the display stays on — that's what shows the OF OF. Samsung says service isn't required — turning it off makes the fridge cool again. On Top Freezer models, also make sure neither compartment is set to Off.
- What to do
- On most panels on the outside of the left door, touch and hold the top two buttons on the left side together for 5–8 seconds, until you hear a chime that sounds different from a single button press. On newer models, also hold the top button on the right side. On Family Hub models, tap Apps → Fridge Manager → Fridge Settings → Cooling Off → Deactivate → Proceed. Panels in other places (door frame, inside wall, BESPOKE) use different buttons, so follow your user manual.
- If nothing changes
- If the display goes back to OF OF, repeat the button hold. If Cooling Off Mode isn't showing, check for an error code.
Check for an error code
- What to look for
- A code on the display, or a blinking temperature display. On Family Hub models, run Self Check (Apps → Fridge Manager → Fridge Settings → Self Check → Start) to see current and past codes.
- What it indicates
- Per Samsung, an error code may mean the fridge needs service and no other troubleshooting is needed. A blinking temperature display means the fridge has detected that a compartment is too warm.
- What to do
- Look up the code in Brand-Specific Info below and follow only what it says. If no code is showing, power cycle the fridge: unplug it or switch off its breaker for 2 minutes, then restore power. As it reboots it runs a self-test and displays a code if it finds a problem. All icons flashing right after power returns is normal — that's the self-test.
- If nothing changes
- If there's still no code, check when the temperature was last changed.
Give a new temperature setting time to settle
- What to look for
- When the temperature was last set, and whether food (not just the air) is cold.
- What it indicates
- Samsung says it can take up to 4 hours for the display to show the temperature you set, and up to 28 hours for the fridge to actually reach it with the doors closed. The air always feels warm right after opening the door, because the cold air rushes out.
- What to do
- Wait the full 28 hours before deciding it's faulty. To check, touch metal or glass containers inside rather than feeling the air. If you need more cooling, set the temperature lower, or use Power Cool or Power Freeze.
- If nothing changes
- If the display is still blinking 28 hours after you adjusted the temperature, request service. Otherwise, check airflow.
Clear the airflow inside and out
- What to look for
- Clearance around the fridge, food near the interior vents, how full it is, and where it's located.
- What it indicates
- The fridge cools by expelling heat, so it needs room to breathe. Samsung recommends 2 inches of clearance at the top, back and sides, and 2 inches between food and the interior vents. A fridge that's at least two-thirds full has less warm air to cool each time the door opens. A spot next to an oven or in direct sunlight makes it work harder — and so does a room below 55°F.
- What to do
- Make room around the cabinet, move food away from the vents, keep it at least two-thirds stocked, and let hot food cool to room temperature before putting it in. If frost is covering the vents, wipe light frost away with a damp cloth and dry it, use a plastic scraper on heavier patches, and defrost the fridge if the buildup is too heavy to clear by hand. Frost on the vents blocks airflow even after you move the food.
- If nothing changes
- Check the door seals.
Clean and test the door seals
- What to look for
- Dirt on the seals, frost or condensation along the inside edge near the seal, and whether a dollar bill pulls out easily.
- What it indicates
- Dirty or damaged seals let warm, moist air in, which both warms the fridge and causes frost. Frost near the seal shows where the door isn't sealing. A new fridge that isn't level from left to right can fail the seal test simply because the doors aren't aligned.
- What to do
- Clean the seals with a damp cloth and dish soap. Then close the door on a dollar bill placed halfway in and pull it out — slight resistance means the seal works. If it slips out, clean the seal again and retest. Level the fridge if the doors look misaligned. If a seal has pulled out of its channel, push it back in; that doesn't need service.
- If nothing changes
- If the seals are warped, torn or damaged, or the test still fails, request service.
Power cycle, wait 3 hours, then request service
- What to look for
- Whether the temperature drops after a full power-down.
- What it indicates
- This is Samsung's last step for a fridge that isn't cooling at all. In most cases, 3 hours is enough to see the temperature start to drop, or 2 hours with Power Cool on.
- What to do
- Unplug the fridge or switch off its breaker, wait 2 minutes, then restore power. Check that the temperatures and other settings are set the way you want them.
- If nothing changes
- If it still isn't cooling, request service from Samsung. If it cools but not enough, go back through the airflow and seal steps. If the fridge runs, shows no code and food isn't spoiling before its normal date, Samsung says service isn't required.
Brand-Specific Info
Error Codes
OF OF / O FF / OFF OFF / scrolling bars- Cooling Off Mode (Demo or Shop mode). Cooling, ice making and the dispenser are off. Service isn't required; turn the mode off (see the first step).
21E- Freezer fan error: no rotation feedback from the fan. Usually the fan has frozen up after the door was left open or because of a gasket gap; it can also be a failed fan motor. Defrost the unit or request service. Make sure the doors can close fully and the gaskets touch all the way round.
22E / 22C- Fridge fan error, which running the fridge with a door left open too long can cause. Unplug it and leave the doors open for a few hours, then plug it back in, close the doors and use it normally. If the code returns, request service.
88 88 / 83E / 85E / 86E- Voltage or power error after a surge, brown-out or a power interruption during startup. Unplug the fridge or switch off its breaker for 60 seconds, then restore power. If the code returns, request service.
PC ER / PC CH- Communication error between components, after a power surge or when the doors aren't properly connected. Turn off power, disconnect and reconnect the wire harness above the door, then restore power. If it returns, request service.
5E / 84C / other codes- 5E is a fridge defrost sensor error and 84C is a compressor lock. For these and any code not listed here, Samsung says to request service.
The temperature display blinks when the fridge detects that a compartment is too warm, and some models chime as well. When power returns after unplugging or an outage, all the icons flash while the fridge runs a self-diagnostic, which is normal. On some panels you have to unlock the controls first by holding Control Lock for 3 seconds, or until it chimes, before any other button combination works.
The Cooling Off Mode button combination depends on where the panel is: outside on the left door (before or after 2015), on the door frame, on top of the Flex compartment, on the inside right wall (before or after 2021), Family Hub, or BESPOKE. Your user manual lists the exact buttons. Top Freezer models can also set a compartment to Off, which disables cooling. Family Hub models can list current and past error codes with Self Check in Fridge Manager.
What Not to Do
- Don't use a hair dryer to defrost. Samsung says it will damage the refrigerator.
- Don't unplug the fridge or tap the panel to clear an error code unless the code's own steps say to. It makes the fault harder for a technician to diagnose.
- Don't judge the temperature by the air right after opening the door. Touch the food or containers instead, and allow up to 28 hours after changing the setting.
- Don't pack food against the interior vents. Blocked vents cause frost, and once frost forms on them it blocks airflow by itself.
Frequently Asked Questions
What does OF OF mean on a Samsung refrigerator?
OF OF (or O FF, OFF OFF, or scrolling temperature bars) means Cooling Off Mode — also called Demo or Shop mode — is on. The fridge won't cool, make ice or dispense water in this mode. It isn't a fault, and Samsung says service isn't required. Turn the mode off and the fridge starts cooling again.
How do I turn off Demo Mode on a Samsung fridge?
On most panels on the outside of the left door, touch and hold the top two buttons on the left side together for 5–8 seconds, until you hear a distinct chime. Newer models also need the top button on the right side. On Family Hub models, go to Apps → Fridge Manager → Fridge Settings → Cooling Off → Deactivate. Other panel types use different buttons, so check your user manual.
How long does a Samsung refrigerator take to cool down?
Samsung says the display can take up to 4 hours to show the temperature you set, and the fridge can take up to 28 hours to actually reach it if the doors stay closed. After a power cycle, 3 hours is usually enough to see the temperature start to drop, or 2 hours with Power Cool on.
How do I reset a Samsung refrigerator that isn't cooling?
If no error code is showing, unplug it or switch off its breaker for 2 minutes, then restore power. It runs a self-test as it reboots and displays a code if it finds a problem. If a code is already showing, don't reset it unless that code's instructions say to.
Why is the temperature display blinking on my Samsung fridge?
A blinking temperature display means the fridge has detected that the compartment is too warm, and some models chime as well. If it's still blinking 28 hours after you adjusted the temperature, request service.
What does 22E mean on a Samsung refrigerator?
22E (or 22C) is a fridge fan error. Running the fridge with a door left open too long can cause it. Unplug it and leave the doors open for a few hours, then plug it back in and close the doors. If the code comes back, request service.
