Washer Troubleshooting
Washer troubleshooting guides, currently covering Whirlpool washers that won't spin or won't drain — from lid-lock, load-balance and suds codes to the drain hose, pump filter and the direct-drive motor coupling that's designed to fail before the motor does.
Common Washer Problems
Right now this hub covers two Whirlpool problems: a washer that won't drain, and one that fills and agitates but won't spin. Rule out the boring cause first. A washer won't spin a tub it hasn't drained, so water left standing at the end of the cycle is a drain problem, not a motor problem. If the tub is empty and the motor hums while the drum sits still, look at the motor coupling. On Whirlpool's direct-drive top-loaders it's a small part designed to break before the motor does.
Choose by Symptom
Is a code on the display? LdL, LdU and Ofb each point at one specific cause, so start there. With no code, first confirm it actually drained, then check the lid switch, then the belt, then the coupling.
Start troubleshootingSafety First
Unplug the washer before pulling any panel. Never tape down or bypass the lid switch to test a spin. The drum reaches 800 to 1200 RPM, and that interlock is what stops it from spinning with the lid open.
View safety tipsPopular Washer Guides
Whirlpool Washer Not Draining: Drain Hose, Pump Filter and Suds
Whirlpool washer won't drain or leaves clothes soaking? Check the drain hose, the pump filter on front-loaders and detergent suds, plus the F9 E1 and Sd codes.
WhirlpoolWhirlpool Washer Not Spinning: Full Diagnosis Guide
Washer fills and agitates but the drum won't spin. Whirlpool-specific diagnosis covering LdL/LdU/Ofb error codes and the direct-drive motor-coupling issue.
